Clik here to view.
How To | Removal and Installation of K.2 Amp Module for Service
ProcedureK.2 Amp Module Removal and Installation for ServiceK8.2 / K10.2 / K12.2PurposeThe following are instructions to show how to properly remove the K.2 amp module from the speaker chassis for the...
View ArticleFAQ | What is the HI-Z selection on Input 2 for on the K.2 series of...
AnswerThe HI-Z (High Impedance) input is a 250 kΩ selection for passive instruments such as electric bass, acoustic guitar, mandolin, banjo, ukulele, etc.
View ArticleClik here to view.
Error / Status | “The file operation could not be completed. Please ensure...
Affected ProductsHardware Model/SeriesTouchMix-30SoftwareControl App: 3.0.22Firmware: 3.0.12462MessageAfter updating TouchMix-30 Control App to version 3.0.22, there is a pop-up: “The file operation...
View ArticleFAQ | What are the Contours used for in the CP Series Loudspeakers?
AnswerThe six (6) Contours are application-specific settings that voice the loudspeaker depending on how you intend to use it.Default – The standard, factory voicing of the loudspeaker for use with...
View ArticleClik here to view.
Error | Protect Mode 4
MessageTHE MESSAGE: “PROTECT MODE 4” | “POSSIBLE SPEAKER DAMAGE DETECTED.” | “NEXT”CausesThe PROTECT MODE 4 message can appear during operation. This indicates that the firmware has detected a...
View ArticleFAQ | Does the KS118 only go 1 dB louder than the KW181?
AnswerWhen measuring the maximum SPL of a loudspeaker or subwoofer, the peak level is taken into account, but not the QUALITY of the sound at that volume. While the KW181 does a great job at performing...
View ArticleFAQ | Which K/KW/KLA models is the KS212C Cardioid Sub compatible with?
AnswerThe new KS212C Cardioid Sub will work with all existing K, KW and KLA loudspeakers. Additionally the KS212C Cardioid Sub will also work with the passive E Series speakers (we strongly recommend...
View ArticleFAQ | Can I plug a Lo/Z input into a CP series loudspeaker?
AnswerNo. Guitars, basses, and other Lo/Z type signals would need a preamp or DI box to balance the signal before hitting the input of the CP series loudspeaker.
View ArticleFAQ | What are the cross-over frequencies for the WL2082 (ILA) speaker?
AnswerThe WL2082 (ILA) speaker, when used in TriAmp mode, has the following basic crossover frequencies:LFHPF 70Hz Butterworth 24dB/octLPF 400Hz Linkwitz-Riley 12dB/octLPF 1.5kHz Linkwitz-Riley...
View ArticleFAQ | Can you enlist remote monitoring and management for fixed installations...
AnswerYes. In upcoming Q-SYS Designer Software select the L Class component from your Inventory and add it to the Schematic. This allows you to control and monitor each device. However, firmware...
View ArticleFAQ | Can the LS118 run in cardioid mode?
AnswerYes, using two or more LS118 side by side, stacked, or back-to-back and engaging the appropriate cardioid setting (Forward/Rear) on each subwoofer will provide a cardioid coverage.
View ArticleFAQ | What does the Limit LED on the CP Series loudspeakers indicate?
AnswerThe Limit LED flickering on and off with dynamic peaks in the music is normal operation. If the LED is lit continuously, the loudspeaker is protecting itself from excessive level and there may be...
View ArticleHow To | Make DSP settings (presets/scenes etc.) and input gains tamper-proof...
ProcedureAn accessory Lock-out Cover (K.2-LOC) is available.
View ArticleFAQ | Can I link multiple Touchmix mixers digitally to act as a larger mixer?
AnswerNo. The Touchmix mixers do not have the ability to patch together digitally to form a larger mixer. However, you can patch mixers together via the various inputs and outputs on what ever open...
View ArticleFAQ | When I select the Cardioid “rear” mode on the KS118, some menu features...
AnswerThe Cardioid rear modes in the KS118 are optimized to provide low frequency directionality, so those functions will remain locked until you turn cardioid mode to “OFF.”
View ArticleFAQ | How do I know if my iPad or iPhone is compatible with iOS17?
AnswerHere is a list of compatible iPhones:https://support.apple.com/guide/iphone/models-compatible-with-ios-17-iphe3fa5df43/iosHere is a list of compatible iPads:...
View ArticleTip | Setting up In Ear Monitors (IEM) with the TouchMix Mixer.
AdviceTouchMix mixers all have the capability to drive wired, stereo In Ear Monitors (IEM) directly. For performers such as keyboardists and drummers who stay at one place on stage, this is a simple...
View ArticleFAQ | Can the Cardioid pattern be turned off of the KS212C?
AnswerNo. Since the KS212C Cardioid Sub is uniquely designed as a single-box cardioid solution, the Cardioid Pattern is always active.
View ArticleTip | TouchMix Application Guide for Musicians and Bands.
AdviceThe TouchMix Application Guide for Musicians and Bands features information on Channel Presets, FX Mute, Wireless Control, and Multi-track Recording among other topics. In addition to the link...
View ArticleFAQ | FAQ: Are the KLA Series loudspeakers IP rated?
AnswerThe KLA Series loudspeakers are intended for installed audio systems in a climate controlled environment. They are not IP rated for permanent outdoor installations.
View Article